Daniel Defense Car Burnsed Loop, Left Hand Shooter

(You save $2.00 )

Out of stock

Out of Stock

Developed over a decade ago by our friend Ashley Burnsed when he determined that the the CAR-15 should have a sling attachment point at the rear of the receiver in a position similar to the loop found on the MP5-A3. The first Burnsed Loop was an old QD Sling Swivel which Burnsed sliced and welded onto a receiver end plate then hand polished with a file to eliminate any burs or rough edges which could abraid the weapon sling. Daniel Defense faithfully carries on the spirit of that original design by paying attention to the little details that others deem insignificant.

  • Fully radiused edges, inside and out to prevent fraying of your sling or your hands
  • A properly posisitioned Loop: High Enough to allow proper manipulation of the safety and yet low enough to keep the meat on your knuckles when performing high speed drills

Materials & Construction

Precision CNC machined from 6061 T6 aluminum and Military Specification Type III Hardcoat Anodized black for a rock hard lasting finish while weighing in at a mere .3 ozs.

  • 6061 T6 Aluminum
  • Type 3 Hard coat black anodizing
  • Weighs only .3 ozs!
  • Made in the USA!


Installation requires removal and re-installation of your existing collapsible stock and buffer tube. A spanner wrench is the only tool necessary to perform this task.