The EMOD is based on the same rugged and practical design as the original Vltor Modstock - with specific features designed from lessons taken from the modern battlefield. The EMOD Combo Kit comes with the regular EMOD Stock, and a Vltor RE-1 Receiver Extension Tube, Carbine Buffer & Spring Set, and Receiver Endplate & Locknut. The EMOD is about one inch longer than the original Modstock and with the rubber butt plate installed, is about a quarter of an inch longer than the CRANE SCB. The increased length of the EMOD is a major benefit when used on scoped rifles (SPR/DMR), as it increases the available comb for any given length of pull. The buttplate of the EMOD is slightly wider and longer at the toe than the regular M4 stock with a noticeable negative pitch, making transitions from the ready feel much more natural. The EMOD was given enough weight to help balance out the normally muzzle heavy feel associated with negative pitch buttstocks. The toe of the buttplate is rolled under; giving the EMOD a superior feel when the weapon is held in the "out of pocket" heads up hold. The buttplate is covered with a removable rubber buttpad that is molded over a metal strike plate. The shape of the buttplate and the rubber buttpad give a solid stock purchase in all situations. The EMOD features more storage in the removable, waterproof side compartments; the EMOD holds up to four CR123 or three AA batteries. There is also an additional weather proof compartment in the clubfoot area of the stock, this compartment can be accessed quickly and holds two AA batteries or other small parts. Constructed from the finest materials, the EMOD will stand up to the most rugged demands. The EMOD Combo Kit is only available with the MilSpec size Receiver Extension Tube and is available in Black, Foliage Green and Flat Dark Earth (tan). The EMOD Combo Kit contains the following items: * EMOD stock kit, with storage compartments. * Milspec Receiver Extension, Part# RE-1 * Carbine Buffer (standard weight), Part# V2-1070-C2 * Carbine/M4 Action Spring, Part# V2-1070-C1 * Receiver End Lock Plate, Part# V2-1069-M1 * Receiver End Lock Nut, Part# V2-1069-M2 SPECS: Style Clubfoot with Butterfly Latch Colors Black, FDE Tan, Foliage Green Receiver Extension Tube Type Mil-Spec Length w/buttpad 7.75 inches (at centerline of tube) Weight 14oz LOP fully collapsed 11.5 inches LOP fully extended 14.75 inches Buttpad angle -5 degrees with decrease to -15 at toe. Sling Attachments Standard military and Quick Disconnect Swivel Socket accessible from both sides. Storage Total of 8ea CR123, or 6ea AA batteries in storage tubes. Additional storage for 2ea AA batteries or small parts in quick access compartment.